Prevention comes down to three habits: keep water moving through the pipes, keep warm air around the plumbing, and know exactly where the main shut-off is before you need it. A dripping faucet, an open cabinet door, and a thermostat that stays above 55°F do most of the work. If a pipe has already burst, shut off the main immediately, then cut power to any circuit in the wet area if you can reach the panel safely.
Why pipes burst after the cold snap, not during it
When water freezes in a pipe, it expands. The ice itself does not always split the pipe. More often, the expanding ice forms a plug that traps water between the freeze and a closed faucet or valve. That trapped water has nowhere to go, and the pressure rises until the pipe fails, sometimes at a joint or fitting well away from the ice.
That is why the first sign often appears during a thaw: the ice melts, water starts moving, and suddenly there is a leak in a wall or a ceiling. A pipe can split on the coldest night and stay quiet for days.
Which pipes freeze first
Cold does not distribute itself evenly through a house. The pipes most likely to freeze are the ones closest to outside air: supply lines in exterior walls, especially behind kitchen and bathroom cabinets; pipes in an unheated crawl space, basement, attic, or garage; hose bibs and the short run that feeds them; and any line that passes through a drafty penetration or a rim joist.
Older homes with little wall insulation, homes on piers, and houses with plumbing in a garage wall are more exposed. So are vacation homes and rentals that sit empty during a cold snap, because no one is there to notice.
Water inside right now?
Call (888) 217-3164Let faucets drip
During a hard freeze, open the faucets fed by the most exposed pipes and let them run at a trickle about the width of a pencil lead. Moving water freezes more slowly than still water, and an open faucet gives the pressure somewhere to go if ice starts to form. A drip will not prevent every freeze, but it lowers the pressure that causes a pipe to split.
Do this on both the hot and cold sides. Hot lines freeze too, and the hot-water line is often the one in the exterior wall. If the fixture is on an exterior wall, it is the one to leave dripping.
A trickle for a few nights is a small thing compared with a burst line, but you do not need to run every faucet. Focus on the sinks, the washing machine, and any fixture on an outside wall.
Open the cabinet doors
Kitchen and bathroom cabinets on exterior walls block warm room air from reaching the plumbing. Open the doors under those sinks during a cold snap and leave them open overnight. If there are children or pets in the house, move cleaning products and chemicals to a higher shelf first.
The same idea applies to a closet or vanity that hides a pipe run: open the door. For a sink against an unheated wall, a small fan aimed into the cabinet can help move room air across the pipes.
Keep the thermostat steady
Set the thermostat to at least 55°F and leave it there through the cold snap, day and night. The overnight setback that saves energy in mild weather can let the far end of the house drop below freezing, especially a room over a garage or a back bathroom.
If you are traveling, do not turn the heat off. Keep it at 55°F or above, and ask someone to check the house or at least the temperature. A smart thermostat that reports temperature remotely is useful for exactly this reason.
Keep interior doors open as well, so warm air reaches bathrooms, laundry rooms, and spare bedrooms. A closed door can turn an unheated room into a cold pocket.
Insulate and seal the weak spots
Insulation is only half the job. Air sealing matters as much, because a draft moves cold air directly against a pipe. Look for gaps where pipes and wiring pass through exterior walls, sill plates, and rim joists, and seal them with caulk or expanding foam approved for the material. Pay attention to the hole where the hose bib enters the house.
Fit foam pipe sleeves on exposed runs in basements, crawl spaces, garages, and attics. Insulate the crawl space floor or walls according to your climate, and cover the crawl space vents in winter if local practice allows it. Do not bury a pipe in insulation without also sealing the draft that reaches it.
If a pipe runs along an exterior wall, a plumber can sometimes reroute it into a warmer interior wall.
Disconnect and drain outdoor lines
Before the first hard freeze, disconnect garden hoses. A hose left connected traps water in the sillcock and the pipe behind it, and that trapped water has nowhere to expand. Shut off the indoor valve that feeds the hose bib, then open the outdoor spigot to drain what remains.
Blow out irrigation lines and sprinkler systems with compressed air, or have the system winterized. Drain pool equipment and fountains that will not run through the winter. Any pipe outside the conditioned envelope that holds water can split.
Know the shut-off before you need it
Find the main shut-off valve and tag it. It is usually where the supply line enters the house, often in a basement, utility closet, garage, or crawl space, and sometimes at the meter near the street. Test it once a year, gently, so you know it turns. Show everyone in the house where it is, including a house sitter.
If you leave for an extended trip in winter, either keep the heat at 55°F or shut off the main and drain the system by opening the lowest and highest faucets. Draining removes the water that could freeze, but the house has no water while you are gone.
If a pipe bursts: the first ten minutes
Shut off the main valve first. Everything else can follow. If water is spraying near an outlet or a light fixture, do not touch anything electrical; leave the room and cut power at the panel only if you can reach it without wading.
Open the lowest faucet in the house to drain the lines and reduce pressure. Then contain the water with towels, buckets, and a wet vacuum if the area is safe. Move furniture, electronics, and rugs away from the wet zone, lifting rather than dragging.
Photograph the source and the water line before cleanup, then call for help. A burst pipe usually means water inside a wall or ceiling, not just on the floor. If water has reached carpet, drywall, or a finished basement, see water damage restoration for what the drying process involves.
If a pipe is frozen but has not split
Turn the faucet on and leave it open. Then warm the pipe gradually, starting at the end closest to the faucet and working back toward the freeze. A hair dryer on a low setting, a heat lamp kept at a safe distance, or towels soaked in warm water are the usual tools.
Do not use an open flame, a charcoal grill, or a blowtorch. Besides the fire risk, concentrated heat can damage the pipe or a soldered joint and turn a freeze into a burst. Do not pour boiling water on a pipe inside a wall, and do not use a space heater in a confined crawl space.
If water starts flowing, keep warming until the pressure is normal, then watch for leaks. If nothing happens after a reasonable effort, or if you see a bulge or a crack, stop and call a plumber. The pipe may already be split.
After the thaw
Walk the house and look for new stains, soft drywall, bubbling paint, or a musty smell. Check under sinks, around the water heater, and along the ceiling below upstairs bathrooms. A pipe that split inside a wall may not show water until the ice melts.
If you suspect a hidden leak, shut off every fixture and appliance that uses water, then watch the water meter. A meter that keeps moving with nothing running usually means water is escaping somewhere. Turn the main off and call a plumber.
If water did get in, treat it like any other water loss: document it, get the standing water out, and start drying before mold has a chance to establish. Our guide to the first 24 hours after water damage walks through the order, and our homeowners insurance guide covers whether a burst pipe is likely to be covered.
FAQ
At what temperature do pipes freeze?
Water freezes at 32°F, but the risk depends on exposure, wind, insulation, and how long the cold lasts. Pipes in exterior walls or unheated spaces can freeze when the outdoor temperature stays below freezing for hours.
Should I leave a faucet dripping during a cold snap?
Yes, during a hard freeze. A pencil-lead trickle keeps water moving and gives pressure somewhere to escape. Focus on fixtures on exterior walls.
Do open cabinet doors really help?
They do when the cabinet sits against an exterior wall. Room air reaches the pipes and reduces the chance of a freeze. Move cleaning products out of reach first.
Can I thaw a frozen pipe with a blowtorch?
No. Open flame near a wall cavity is a fire risk and can damage the pipe. Use a hair dryer, a heat lamp at a safe distance, or warm towels, and keep the faucet open.
Does homeowners insurance cover a burst pipe?
It often does when the failure is sudden, though the pipe repair itself may not be covered and your deductible applies. Coverage depends on your policy and how quickly the damage was reported.
This article is general information, not an on-site assessment or insurance determination. UFlood is an independent referral service. Call the 24/7 line for help finding a local provider.